Three-component hydrophilic gel for consolidating the ground and for injecting concrete barriers. TECHNICAL DATA: Consistency: comp A (liquid), comp B (liquid), comp C (solid). Viscosity of mix…
Three-component hydrophilic gel for consolidating the ground and for injecting…
Two-component epoxy-acrylic paint in water dispersion for the protection of cementitious substrates Where to use Lining of concrete surfaces or cement-based renders inside tunnels for the protection…
Two-component epoxy-acrylic paint in water dispersion for the protection of…
Fluid epoxy impregnator in water dispersion for consolidating and priming wooden structures. TECHNICAL DATA: Mixing ratio: comp. A : comp. B = 1 : 1. Workability time: 30-40 minutes. Final hardening…
Fluid epoxy impregnator in water dispersion for consolidating and priming…
Fine-grained thixotropic, fibre-reinforced, controlled-shrinkage, medium-strength (30 N/mm2) mortar for repairing concrete Where to use To repair the concrete cover on deteriorated concrete…
Pultruded carbon fibre tube impregnated with epoxy resin for reinforced injections in masonry. TECHNICAL DATA: Tensile modulus of elasticity: 170,000 N/mm ² . Content of fibre by weight: 68%. Tensile…
Pultruded carbon fibre tube impregnated with epoxy resin for reinforced…
PVC waterproofing and isolating sheet reinforced with glass fibres, for laying internal resilient and fabric floors on substrates which have cracks, which are particularly dirty or damp or which are…
PVC waterproofing and isolating sheet reinforced with glass fibres, for laying…
Admixture for enhancing the pumpability of sprayed concrete Where to use Mapeplast UTT is exclusively suitable for sprayed concretes. Thanks to its special formulation, Mapeplast UTT gives…
Admixture for enhancing the pumpability of sprayed concrete Where to use…
Aerating product for concrete and cementitious mortar. Technical data: Dosage: concrete: from 30 to 150 ml every 100 kg of cement. cementitious mortar: from 100 to 300 ml every 100 kg of binder.…
Aerating product for concrete and cementitious mortar. Technical data: Dosage:…
Super-plasticizing admixture for concrete Where to use Mapefluid IF328 is used for: – precast concrete; – quality concrete. Dosage By volume: 0.8-2.1 l per 100 kg of cement. Packaging 200 l drums;…
Super-plasticizing admixture for concrete Where to use Mapefluid IF328 is used…
Sodium aluminate-based liquid setting accelerator for mortar and shotcrete Where to use – Securing surfaces during tunnelling, mine passages, shafts, dams, etc., during excavation. – Levelling layers…
Sodium aluminate-based liquid setting accelerator for mortar and shotcrete…
Alkali-free accelerator for shotcrete Where to use • Securing surfaces during tunnelling. • Inner lining even in presence of very squeezing soils. • Shotcrete for structural tunnel repairs. •…
Alkali-free accelerator for shotcrete Where to use • Securing surfaces during…
Powder setting accelerator for shotcrete Where to use • Securing surfaces during tunnelling. • Inner lining even in presence of very squeezing soils. • Shotcrete for structural tunnel repairs. •…
Powder setting accelerator for shotcrete Where to use • Securing surfaces…
