Apply the product with a low-pressure manual sprayer or brush and leave it to react for a few minutes, making sure it penetrates deep down into the substrate. Remove the mould with a stiff brush.
Position the panels on the substrate in horizontal rows. The panels should be staggered at the midpoint of their longest side and by 25% in height with respect to the layout of the existing insulating panels.
6
Fasteners MAPETHERM-EJOTHERM S1
Insert the fasteners into the set adhesive until they reach the load-bearing portion of the substrate.
Apply two successive layers of the skimming mortar to form a layer 4-5 mm thick. Place the reinforcing mesh on the first layer of skimming mortar while still fresh, overlapping adjacent pieces of mesh by at least 10 cm.
Apply one or two coats of finish, according to the texture of the surface, with a stainless steel trowel. Finish off the surface with a sponge or plastic float.
Technical pack
Download with one click all technical documents related to this solution
Keep in touch
